![]() Reinforced Concrete BIM Designers - Columns For columns the properties of the longitudinal and transversal reinforcement for any of the three sections considered: upper, main and lower bars can be adjusted. Some dialogues may vary in appearance depending on the platform but the available options remain the same.) Users can also adjust the main/secondary longitudinal reinforcement bars and the transversal bars as required. In the majority of cases the calculated reinforcement cage should not need to be changed but using the Generated Reinforcement panel, the resulting reinforcement can be revised and adjusted to accommodate additional requirements for each type of element. ![]() Once the structural design of the footing is completed, the rebar cage properties (diameter, spacing, covers, etc) are set in accordance with the selected country design code. ![]() ![]() After launching the 'Preliminary sizing' command the elements properties from the model can be further verified during the design process. The footing's geometry is adjusted and a rebar cage generated as a result of an iterative calculation considering the applied loads.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |